BASIC WORSKHOP PRACTICE

What is the use of this gauge?

Check the internal radius of the job Check the diameter of cylindrical job Check the height and parallelism of job Set the job on machines parallel to datum

What is the name of the file?

Rasp cut file Single cut file Double cut file Curved cut file

What is the name of the tool?

Divider Inside calliper Odd leg calliper Outside calliper

What is the use of mortise chisel? General chiselling work in wood Making rectangular holes in wood Paring and finishing joints in wood constant Light chiselling cleaning sharp corners and in wood

Which type of stake is used for sharp bends in sheet metal? Square stake Hatchet stake Blow horn stake Bevel edge square stake

Which type of cold chisel is used for squaring materials at the corners? Web chisel Cross cut chisel Half round chisel Diamond point chisel

Which type of caliper is used to draw parallel lines along the outer edges of the materials? Inside caliper Jenny caliper Outside caliper Spring joint caliper

What is the name of the drill bit?

Flat drill bit Taper shank bit Countersink bit Straight shank bit

Which file is used for sharpening the blunt teeth of a tenon saw? Square file Round file Triangular file Half round file

Name the part marked 'x' of the file.

Edge Heel Tang Shoulder

What is the name of the tool?

Jenny caliper Inside caliper Outside caliper Firm joint caliper

What is the name of the angle marked ‘X’ of the chisel?

Rake angle Point angle Clearance angle inclined angle

What is the use of firmer chisel? Paring and finishing joints General chiseling work Making rectangular holes in wood Light chiseling and to clean sharp corner

Which type of half lap joint is used if one part of a job meets another part at some distance from the ends? End-lap input Cross-lap joint Middle-lap joint Corner-half lap joint

Which type of notch is used for making a metal tray with 90° bend and an inside flange? 'V' notch Slant notch Square notch Straight notch

What is the name of the hammer?

Claw hammer Ball peen hammer Cross peen hammer Straight peen hammer

Which defect in timber is caused due to improper seasoning? Knot Twisting Cracking Cupping

Which type of notch is used for bending the edge of the sheet? ‘V’ notch Slant notch Square notch Straight notch

What is the purpose of cross cut cold chisel? Cutting keyways Cutting curved grooves Squaring materials at corners Removing metal from large flat surface

Which type of curve cutting hand saw is used for internal cutting in wood? Compass saw Key hole saw Coping saw Fret saw

What is the name of the stake used for sheet metal work?

Square stake Hatchet stake Blow-horn stake Bevel-edge square stake

What is the name of the tool?

Claw hammer Tack hammer Cross pein hammer Straight pein hammer

Which causes knot defects in timbers? Defective storage Uneven shrinkage Growth of branches Improper seasoning